how to cut wood veneer board
Applying wood veneer was once rumored to be a difficult task, reserved mainly for seasoned professionals. these days, since tools and supplies are readily available and many of the methods are so simple, even a novice woodworker can easily master the process.. To veneer wood, start by cutting the veneer to size leaving as little overhang as possible. next, roll contact cement on both the substrate's surface and the veneer with a short nap roller and wait about 5-10 minutes until the adhesive feels tacky to the touch. then, position the veneer on top of the substrate, lining them up perfectly, and. Turn on the band saw and position the pencil line parallel to the blade at the point where the blade should enter the wood. to make the cut, hold the board flat on the table and ease the board through the moving blade. do not force the wood, but ease it through with slow steady pressure, allowing the blade to do all of the work.. how to cut wood veneer board
Using a thickness planer to make thin veneer and plane super thin wood is actually an easy task with a planer sled. you can use this for laminated wood and bent wood lamination, or splines for. Run tape across the cut line in order to support the veneer and reduced chipping from tear out. use a clean blade that's designed specifically for cutting veneers. make sure there is adequate support all the way around for the material being cut. use a moderate to slow feed rate to minimize the rate of wood removal. don't try to rush the cut..
0 comments:
Post a Comment